I am old to FF, but new to csc (concentric slave cylinder) type throwout bearings on these cars.
When I get ready to mate my engine to the Mk9, the throwout bearing won't stay in place, so I can't put them together. I thought the problem was worn tangs on the i.d. of the bearing, so I bought two and they pop off too.
I once thought the idea was to glue the bearing to the boot on the trans side but that doesn't hold the bearing back far enough.
Is it ok the glue it to the clutch diaphragm as shown? I used a very, very light skim of rtv.
When I get ready to mate my engine to the Mk9, the throwout bearing won't stay in place, so I can't put them together. I thought the problem was worn tangs on the i.d. of the bearing, so I bought two and they pop off too.
I once thought the idea was to glue the bearing to the boot on the trans side but that doesn't hold the bearing back far enough.
Is it ok the glue it to the clutch diaphragm as shown? I used a very, very light skim of rtv.
How to hold throwout brng in place
Aucun commentaire:
Enregistrer un commentaire