Gents;
I was thinking of fabricating a trammel bar for my RF-95 (as well as any other car), but all my stuff is in Minnesota.
Similar to this, but I think I can do much better. What I need is all IDs of the typical rod ends, say from 10-32 (ARB front links) to 1/2" (or the lower rear A-frames on the RF95), which ever are larger.
If I make one, I can easily make a couple dozen or more for resale at my cost plus a couple bucks to help pay for the miter saw + shipping.
Any help?
V/r
Iverson
I was thinking of fabricating a trammel bar for my RF-95 (as well as any other car), but all my stuff is in Minnesota.
Similar to this, but I think I can do much better. What I need is all IDs of the typical rod ends, say from 10-32 (ARB front links) to 1/2" (or the lower rear A-frames on the RF95), which ever are larger.
If I make one, I can easily make a couple dozen or more for resale at my cost plus a couple bucks to help pay for the miter saw + shipping.
Any help?
V/r
Iverson
Rod end IDs
Aucun commentaire:
Enregistrer un commentaire